There are a whole lot of reasons to build raised vegetable gardens — the kind that sit above ground within a frame made of wood or other material. If your land has sandy, claylike, or hard-packed soil (or if you don’t know and don’t give a hoot about the difference), you can provide perfect conditions for whatever you’re keen on growing.
Plants are lifted out of the way of rowdy pets and little ones, and your soil warms up earlier and stays that way longer, extending the growing season and providing gentler conditions for new seeds and delicate transplants. Fruits, veggies, and ornamentals will send their roots deeper in search of water, which means a stronger foundation and improved health. And raised beds keep your space tidy. Best of all, they couldn’t be easier to make. Especially if you’re getting into growing for the first time, you’re going to want some beds of your own.
The beauty of this particular raised bed build is that it is cheap and easy to build. The wood and rebar will cost you no more than $50 if you’re using untreated pine planks, and the entire build can be completed in less than an hour’s time. The untreated pine might only last 3 to 5 years, but due to the nature of this build, each board is easily replaceable without taking apart the entire bed.
For a 2.4m x 1.2m raised bed, you’ll need:
2x 300×50 planks, each 2.4m the 1 last update 2020/07/14 long2x 300×50 planks, each 2.4m long
Woodworking Planshow to Woodworking Plans for 2x 300×50 planks, each 1.2m long
12 pieces of rebar, each 600mm long
A rubber mallet
Newspaper or cardboard
Soil to fill the finished frame
- Position your boards.
On a level section of ground, lay the boards down with their inner corners touching. Stand one long board on its side, and, using a rubber mallet, hammer two pieces of rebar 300mm from each corner, a few inches deep into the ground.
- Prop up the short sides.
Use a piece of rebar at the center of each for temporary support. Next, prop up the second long side and adjust the alignment of your frame as necessary. Then hammer rebar a 100mm deep, 300mm from each corner of the second long side.
- Add more support.
Hammer rebar a few inches deep a foot from each corner of the short sides and remove the temporary supports. Add two pieces of rebar 600mm apart along each long side. These will reinforce the frame when it’s filled with soil. Then hammer in the rebar until 200mm are exposed above ground.
- Fill it up.
Line the bottom of your frame with newspaper or cardboard and wet it thoroughly. Finally, fill your bed with soil to within a few inches of the top.
The possibilities for building materials are endless:
Weave a frame with long, flexible sticks. The kids will have fun collecting them, and the results are the 1 last update 2020/07/14 usually Pinterest-worthy.Weave a frame with long, flexible sticks. The kids will have fun collecting them, and the results are usually Pinterest-worthy.
Woodworking Planshow to Woodworking Plans for Logs
Woodworking Planshow to Woodworking Plans for If you’ve recently cleared a tree, logs can be a cost-effective material. Choose pieces that are straight and at least 300mm in diameter.
Placing the blocks with open ends up provides extra growing room. Tuck herbs or decorative flowers into the cavities.
High and Mighty
Woodworking Planshow to Woodworking Plans for A waist-high bed is accessible to those with physical limitations.
Build your beds somewhere that receives at least five to six hours of daily sunlight — the more, the better! Orient them north to south to prevent plants from shading each other out. Beds should be at least 300mm wide, though no more than 1.2m across to make weeding and harvesting manageable. 1.8m – 2.4m long is typical and cost-effective. 200-250mm is an ideal height to accommodate strong roots. Leave at least 1m between beds for walking and wheelbarrow access.
The brilliance of a plank-and-rebar design (see above) is that each individual wall is easily replaced. Try naturally rot-resistant varieties of wood, such for 1 last update 2020/07/14 as macrocarpa and gumThe brilliance of a plank-and-rebar design (see above) is that each individual wall is easily replaced. Try naturally rot-resistant varieties of wood, such as macrocarpa and gum
You want the kind that’s dark, rich, and loaded with microorganisms. Fill your beds with a mix of 50 to 60% good-quality topsoil and 40 to 50% well-aged compost. Before each new growing season, test your soil for pH and nutrient content. You can buy a kit at most home-improvement stores. If your test shows a need for additional nutrients like nitrogen and potassium, raise levels by working in amendments such as bone meal and kelp. Dress beds with an additional 25mm of compost later in the growing season to increase organic matter and boost soil health.
If you’re building your beds in high summer, it’s not too late to plant fall crops. Sow seeds like carrots and lettuce directly into the soil, or buy midseason transplants for crops like kale and broccoli. If you’d rather wait until next year to plant, cover the soil in your new raised beds with a mixture of grass clippings and shredded leaves in autumn — the material will compost before you’re ready to start in spring.
Raised beds have fantastic drainage, which is great for plant health, but they dry out quickly. Give your plants a long drink in the early evening, but check them again on hot summer afternoons. If the soil is dry, it’s a real scorcher outside, or you live in a hot and arid climate, water again. A programmable drip-irrigation system is inexpensive and convenient, delivering consistent moisture straight to plant roots. Invest in a timer component to save money and water.
Once you have installed your garden bed, take photos and share them with your friends and family as this could inspire them too.
Woodworking Planshow to Woodworking Plans for Get growing!