Woodworking Plans

πŸ”₯+ Woodworking Plans 07 Jul 2020 You could model your hole on some other floor-plan. We have, for example, a partial description of the house at Crickhollow: At last they came to ...

Woodworking Plans Water can drain better and oxygen reaches the roots. the bigger the pots you use, the better your plants grow. Buy 9 of the biggest ones that fit into your tent. The ...

Wood Six Pack Plans PDF
Skip to content
Stay at home and be safe! Order online with 18% OFF promo code STAYSAFE
Stay at home and be safe! Order online with 18% OFF promo code STAYSAFE
Woodworking Planshow to Woodworking Plans for Menu
Free Shipping *

& Tax Free Outside CA

View cart
  • Login
Woodworking Planshow to Woodworking Plans for Close

Woodworking Planshow to Woodworking Plans for This tutorial will show you how to install the 82mm BMW backlit LED trunk or hood emblem light kit (35-420). While the pictures depict the Chevrolet emblem, the installation process will be the same.

1) Use a flat head screw driver to carefully pry off the OE emblem from the vehicle. Use a microfiber towel to cover the paint from any harm when doing so, please take caution to not damage your paint. You can try using a heat gun to soften the adhesive on the emblem.

Woodworking Planshow to Woodworking Plans for

2) Once the emblem has been removed, remove any leftover adhesive on the paint so that a proper bond can be achieved. Compare the size of our LED backing and your stock emblem to make sure the size is the same before proceeding.

3) Open your trunk and remove any trim that covers the back of the trunk. Your vehicle may differ in the amount of screws or tabs used to hold the trim to the trunk.

4) Route the wires through the holes that are present in the trunk and tap the wires to a power source that you want the light to turn on with such as your tail lights or license plate lights. Connect the red wire to the positive wire and the black to the negative wire of the power source.

5) Before proceeding with the the 1 last update 2020/07/07 rest of the installation, power up the lights to make sure that the LED emblem works. Once you confirm, please proceed with the following steps for installation.5) Before proceeding with the rest of the installation, power up the lights to make sure that the LED emblem works. Once you confirm, please proceed with the following steps for installation.

6) Scrape off any excessive adhesive on the OE emblem before sticking it onto our LED. Remove the adhesive covering off the LED. Carefully position the two pieces together and apply. Once the bond has been achieved, position the items onto the trunk, press down and hold for a few minutes. Use painter''ve waited a few minutes for the adhesive to bond, remove the tape and enjoy your new Emblem background LED light!

Woodworking Planshow to Woodworking Plans for

Notes: This guide is meant to be used as assistance only, it is not mean to provide you a highly detailed step-by-step procedure to install the lights. This guide assumes that you have basic and general knowledge of how to remove and install lights. iJDMTOY is not responsible for any damages or problems caused by improper installation or misuse of this guide. Professional installation is recommended for those who are not experienced with working on their vehicles.

Added to your cart:

Cart subtotal